Photo showing "The Boat Shed" where the top balcony was waterproofed with Wrimco pure urethane Multithane because of the many studs set in the concrete that supported timber decking. The upturned timber hull of the boat was one of the more unusual features of the building
Location: Maroubra
Waterproofer: Wrimco Waterproofing Contractor
Photo showing planters with Wrimco SBS waterproofing membrane applied after priming and before spot torching PB4 protection board.
Location: Bellevue Hill
Builder: Abuild Pro Construction
Waterproofer: Wrimco Waterproofing Contractor
Photo showing planters with Wrimco SBS waterproofing membrane applied after priming and before spot torching PB4 protection board over basement.
Location: Curzon House
Waterproofer: Wrimco Waterproofing Contractor
Location:
Edinburgh Rd, Castlecrag
Waterproofer: Wrimco Waterproofing Contractor
Photo showing Wrimco SBS membrane torch applied to a planter. After detailing the corners with 30 x 30mm fillets, the sheet was applied in 1m wide strips from top of one down, across and up to the other side
Photograph showing PACTIV PB4 dedicated protection board spot torched to the SBS waterproof membrane in a large planter by the roadside over the garage. Unlike PolyPropylene (PP) profile board which is almost as inert as Teflon, the PB4 is Extruded Polystyrene (XPS) foam which adheres brilliantly to the surface of the SBS made molten with a pass of the propane gas torch and hence is referred to as no nails PB4.
Photograph showing planter box on roof waterproofed with Wrimco SBS. the base is to be insulated with 75mm Wrimco XPS and the sides with PACTIV PB4 protection board followed by 30mm drainage cell and 1mm geotextile/filter fabric.
Photo showing pathway and planters between main building and separate units where Wrimco SBS torch applied waterproofing membrane, PB4 protection board and 30mm drainage cell with 1mm filter fabric was used.
Planter Box will be waterproofed with Wrimco SBS torch on membrane.
Photo showing the historical building in the background with planter adjacent to extensive landscaped area, all waterproofed with Wrimco SBS torch on membrane, PB4 and drainage cell system.
Photo showing planters above second level waterproofed with Wrimco SBS torch on membrane, PB4 protection board held in place with 20x10x20 Z section and 30mm drainage cell with 1mm filter fabric.
Planter Box Waterproofed with Wrimco Bitumen Sheet Membrane
Location: Vaucluse
Waterproofer: Wrimco Waterproofing Contractor
Photo showing aluminium Z-section 20 X 10 X 20 which has been sealed and mechanically fixed 100mm below the top of the blockwork. Wrimco PB4 protection board was first spot torched to the membrane and held in place by the Z-section to provide a high quality, low maintenance finish. The applicator is standing on the 50mm double washed river sand used to protect the 1mm PP filter fabric laid over the 30mm PP drainage cell at the base of the planter.
After rendering down onto the Z-section, the top of the render was waterproofed with Duromastic ACS prior to painting to prevent water bypassing the membrane system and to stop unsightly efflorescence (calcium carbonate formed by water reacting with lime from the render).
Waterproof Plant Box with Wrimco SBS Sheet membrane
