Wrimco Drill Pump is a light weight and handy electrically operated pump used for high pressure chemical grouting. It is a simple to use injection pump especially designed for the injection of single shot polyurethane grouts or epoxy resins. It is the perfect machine for daily use and suitable for performing both commercial work and residential injection, with its compact design it is ideal for use in confined areas.
Wrimco Drill Pump is a light weight and handy electrically operated pump used for high pressure chemical grouting. It is a simple to use injection pump especially designed for the injection of single shot polyurethane grouts or epoxy resins. It is the perfect machine for daily use and suitable for performing both commercial work and residential injection, with its compact design it is ideal for use in confined areas.
Wrimco Drill
Pump is simple in design and construction. It consists of the following parts.
Electrical drill
Gear box
Pressure Pump
Pressure converter
Feeding hopper
Pressure gauge
High pressure supply hose
Injection head with on-off valve
Technical Data
|
Source
|
110V and 220V
|
Flow
|
0.74 L/minute
|
Description
Key Benefits
Good mechanical performance, little noise and no pollution.
Portable: It is small, light and easy to handle
High efficiency: It can reach 0 ~ 180bar work pressure within several seconds
Safe usage: With its reliable and practical structure, it is both user-friendly and safe to use
High pressure: With a grouting pressure of 0 ~ 180bar it can easily inject grouts or resins into tiny cracks and holes in concrete structures.
Pump Guidelines
Setting up
Screw the pressure hose into front of the pump and tighten firmly. Place the electronic drill to the drill holding device and tighten the clamping ring.
Note: Use CLOCKWISE Rotation setting on drill only. Do NOT pump water. Do NOT operate the pump when it is dry.
Using the pump
Set the drill on low speed to start the pumping process, once the desired working pressure is obtained set the dial switch of the electronic drill to maintain the pressure.
Make sure that no foreign particles will enter the pump together with the injection products.
Ongoing Maintenance
Cleaning
Always make sure that the pump is cleaned after injection by flushing Cleaners until all resin residues are removed, the pump should then be left charged with engine oil and flushed once again with the cleaner prior to next use.
Health & Safety
Wrimco Drill Pump should only be used as directed. Our recommendations for protective equipment should be strictly adhered to for your personal protection.