Excellent work time
Good chemical resistance
Abrasion and impact resistant
Can be sprayed
TREMCoat MC is a high build maintenance coating, which is resistant to abrasion, impact and a wide range of chemicals.
Concrete walls and floors
Construction and mining industries
Sewage holding tanks
2 hours @ 25
TACK FREE TIME:
hours @ 25
4 - 12 HOURS @ 25
Approx. 5m2 / litre / coat
7 days @ 25
Concrete should be sound and free of all loose and deleterious materials, mechanical cleaning such as captive blasting, scabbling or grinding is best. If acid washing ensure surface is well rinsed afterwards. For maximum adhesion allow 24 hours drying prior to application.
Metal should be grit blasted to a Class 3 finish, otherwise mechanically abrade to a bright metal finish. Wire brushing is not recommended.
Method of application
Mix resin and hardener with Tremco Mixing Paddle fitted to (500 rpm) power drill. Mix for a minimum of 3 minutes until homogeneous.
Apply in 3 coats minimum with a short nap roller, squeegee or airless spray. Second coat should be applied as soon as the first coat has cured (4-12 hours) but no more than 24 hours. Final coating thickness should be 400-500/microns.
Chemical resistance at full cure
TREMCoat MC has good resistance to the following chemicals.
Distilled water at 40
Petrol, Diesel Fuel, Crude oil, Transformer Oil
Sulphuric Acid less than 70% concentration
Hydrochloric Acid less than 30% concentration
Toluene, Sodium Hydroxide
Dry storage below 25
Can be stored unopened up to 2 years.
Tools and equipment should be cleaned prior to hardening with Tremco IPA Solvent. Do not use for washing hands.
Health and safety precautions
The Material Safety Data Sheet (MSDS) must be read and understood prior to use. As with all Epoxy Products, wear rubber gloves and overalls. Prolonged exposure can cause dermatitis. Ensure adequate ventilation. Do not mix packs unless accurate measuring equipment is available