Kemseal WBE is a high-build, two component water based
epoxy coating used to prime and seal concrete and masonry surfaces. It cures to
a tough chemical and water resistant coating having excellent adhesion to sound
concrete.
PRINCIPAL FEATURES:
-
Waterbased, user friendly
-
Low odour
-
Excellent water resistance
-
Excellent adhesion to fresh
concrete
-
Applicable to damp surfaces
-
Resists hydrostatic pressure
when cured
-
Excellent oil resistance
USE AREAS
-
Fish Ponds
-
Retaining
Walls
-
Reverse
Tanking
-
Waterproofing
concrete slabs before vinyl and timber overlays
-
Primer for
membranes.
-
Dust
Sealing concrete floors
-
Chemical
resistant floor/wall coating
-
Concrete
curing membrane
-
Moisture
barrier on damp walls/floors
APPLICATION
All surfaces to be free of contamination, sound and not
more than slightly damp. If necessary acid etch and water blast unsound or
powdery concrete surfaces. Remove all acid residue before coating. Pre-mix Pack
A and Pack B separately, then mix equal parts together for 5 minutes. Use mixed
material within 1.5 hours at 20oC. To seal concrete, apply 2 or more coats by
brush or roller at 3 m2 /litre minimum per coat, to provide a seamless epoxy
lining. Care should be taken to fill all voids and pin holes. Kemseal WBE is
rigid when cured and will not absorb movement cracks. When priming with Kemseal
WBE, dilute with water up to 50%, depending on porosity and nature of
substrate. Time between coats, 5 hours to 24 hours at 20oC. Minimum cure
temperature -10oC. Do not apply at Relative Humidity Above 85%. Surfaces may be
slightly damp but not wet. See Kemforte MSDS Disclaimer: The user is
responsible to follow current data sheets. The information shown here is as up
to date and correct in detail as possible and is intended to give a fair description
of the product and its capabilities based on actual service history. In
practice, the substrate and environmental conditions vary widely, making it
essential for the user to determine the products suitability for a particular
application and that the product is not used beyond its physical limitations.
As the use of this material is beyond the manufacturers control, no guarantee
expressed or implied is made as to such. Liability is limited to replacement of
material proved faulty. Site Inspections, suggestions made or application
instructions by Kemforte Systems, given verbally or in writing are always to be
reviewed by; installers, contractors, consultants and building owners
responsible for design and/or installation to ensure they are appropriate to the
specific application or area of use, prior to application. Kemforte Systems
terms and conditions of sale apply.
GENERAL INFORMATION
-
Shelf life: 12 months
-
Pot life: 1-2 hours at 20oc
-
Touch dry: 4 - 5 hours at 20oc
-
Full cure: 5 days at 20oc
-
Weather resistance: good
-
Color (mixed): grey
-
Mix ratio: 1 part a: 1 part b, by volume
-
Clean up: clean equipment with water before curing
commences
-
Storage: above 5°c
|